Performance indicators for thermal insulation pipes serve as the primary criteria for evaluating their quality and suitability. Taking the commonly used prefabricated, direct-buried polyurethane-insulated pipe as an example, its key performance characteristics-encompassing thermal, physical, mechanical, and protective aspects-directly influence the operational efficiency and safety of the pipeline network. In terms of thermal performance, thermal conductivity is the most critical metric; high-quality products can achieve values as low as 0.022 W/(m·K), with a typical requirement of no more than 0.033 W/(m·K). These pipes are designed for long-term use within a temperature range of -50°C to 120°C, with heat loss controlled to within 5%, ensuring high efficiency and energy conservation. Regarding physical properties, the insulation layer must have a density of at least 60 kg/m³, a closed-cell content exceeding 88%, and a water absorption rate of less than 10%; these specifications ensure stable, long-lasting insulation performance and prevent failure caused by water ingress. Mechanically, the pipes must exhibit a compressive strength of at least 0.3 MPa at 10% deformation and an axial shear strength of no less than 120 kPa, enabling them to withstand soil loads and stresses induced by thermal expansion and contraction, thereby preventing structural damage. The outer protective casing is made of high-density polyethylene (HDPE)-with a density of ≥940 kg/m³ and a tensile strength of ≥20 MPa-providing a robust shell for the insulation layer. Fire performance is measured by the oxygen index, which is generally required to be ≥26 to meet fire safety standards. These indicators are based on the national standard GB/T 29047-2021. When installed correctly, such pipes have a design service life of 30 to 50 years; some products even feature integrated leak-detection wires, allowing for the precise location of any leaks. The comprehensive optimization of these performance indicators provides a solid foundation for the long-term, stable operation of heating pipeline networks.

