
If insulated pipes are not stored properly after arriving at the construction site, issues such as the aging of the outer protective casing, moisture absorption by the foam insulation, or water ingress at the pipe ends can occur.
Regarding site selection, the storage area must be level, free of hard debris like gravel, and possess sufficient load-bearing capacity. Effective measures should be taken to prevent the stacked pipes and fittings from collapsing or tipping over.
As for stacking, insulated pipes should not be placed directly on the ground. The storage area must be equipped with pipe supports to keep the pipes elevated above the ground. The stacking height should not exceed 2 meters. Pipes must be protected from direct sunlight, rain, and immersion; if stored outdoors, they should be covered with tarpaulins and kept away from heat or fire sources.
Regarding storage duration, anti-corrosion insulated pipes should not be exposed to sunlight or rain for extended periods. Outdoor storage should not exceed 6 months; if it does, the pipes must be covered with tarpaulins, and the ends of the steel pipes must be sealed. Sealing the pipe ends prevents rainwater and debris from entering the insulation layer.
When it comes to lifting and handling, a crane-not a forklift-must be used. Insulated pipes must be lifted using specialized hoisting straps or similar methods; the use of steel wire ropes is strictly prohibited to avoid damaging the outer protective casing and the insulation layer.
While storage may seem like a minor detail, damage caused by improper storage is often irreversible. Ensuring a level surface, elevating the pipes to prevent moisture, providing covers for sun protection, sealing the pipe ends, controlling stacking height and duration, and following proper lifting procedures-getting these steps right ensures peace of mind once the pipes are buried underground.

