Introduction:
The anti-corrosion film layer of 3PE Anti-corrosion Steel Pipe is composed of three layers, the bottom layer is epoxy powder coating, the middle layer is adhesive layer, and the top layer is polyethylene. This three-layer structure can better protect the steel pipe from corrosion. Moreover, the combination of these three layers of film is tight, and its stability is significantly higher than that of a single anti-corrosion coating. Second, our compressive strength is higher than other steel pipes. Because its film layer is stronger, it will not crack even under high pressure, thus ensuring its reliability. More importantly, our products can avoid corrosion during use and are suitable for various chemical media. Even in high temperature acid-base environment, its chemical stability is still very high. Finally, this product requires no special treatment during construction, and the construction method is basically the same as that of other steel pipes. Its construction speed is fast, and there is no need to wait for a long time for operation, thus greatly saving construction time and cost.
Feature
The three-layer coating of 3PE Anti-corrosion Steel Pipe is composed of an organic primer, an adhesive and a polyethylene coat layer, which can prevent steel pipes from being corroded by acids, alkalis, salts and other chemicals and oxygen, water vapor and other gases on the metal of corrosion. Secondly, the polyethylene outer layer of our product is very closely combined with the steel pipe, so that the overall performance of the steel pipe has been greatly improved. The coating has extremely strong adhesion and good wear resistance, so the surface of the steel pipe generally does not need to be covered with an anti-corrosion layer, and the anti-corrosion effect can be maintained for a long time. More importantly, unlike traditional anti-corrosion steel pipes, this product has a wider range of uses. It is suitable for oil transportation, natural gas, petrochemical, municipal and other fields, and can also be used in groundwater engineering, medicine, food and other industries. Due to its excellent heat insulation, waterproof, fireproof and other characteristics, it can be used in heating, ventilation and air conditioning systems of residential buildings. Finally, our product is a high-performance anti-corrosion pipe with strong anti-corrosion ability, good adhesion and wide application range. With the continuous development of science and technology, its application will become more and more extensive, and it will receive more and more attention in the future market competition.
Technological process:
1. Shot blasting and rust removal on the outer surface of steel pipes
2. Epoxy powder spraying
3. Extruded plastic adhesive
4. Coating tube cooling
5. Electric spark leak detector performs 100% leak detection on coatings
6. Finished pipe end treatment and marking
Advantages:
1. The coating is evenly coated with high toughness;
2. Strong resistance to stress cracking and high impact resistance;
3. High sealing performance and strong insulation performance;
4. Strong resistance to chemical corrosion and waterproofing, aging resistance;
5. Good environmental friendliness and convenient local maintenance;
6. Strong stability; The service life can reach over 50 years.
Storage requirements for 3PE anti-corrosion steel pipe:
1. During storage, it should not be exposed to the scorching sun, rainforest, or soaking. Outdoor storage should be covered with tarpaulin.
2. When placing, the ground should be flat, free from water accumulation, and hard debris such as crushed stones, and the stacking height should not exceed two meters.
3. Measures should be taken for storage to avoid slipping and collapsing, and product and personal safety must be ensured.
4. When the ambient temperature is below -20 ℃, it should not be stored outdoors.
5. The stacking site should be equipped with pipe supports, which should ensure that the lower surface of the anti-corrosion pipe is 150mm above the ground.
6. When storing 3PE anti-corrosion steel pipe, it is strictly prohibited to collide or scratch hard objects.
Hot Tags: 3pe anti-corrosion steel pipe, China 3pe anti-corrosion steel pipe manufacturers, suppliers, factory, External FBE Coating Pipe


